characteristics:
used for pressed assembly of end-plates of all types of rotors;
complete the pressed assembly of front and back end-plates at one time.
full automatic charging, pressed assembly and baiting;
easy change: only change of proper moulds is needed.
it may be connected with smart automatic belt line without human intervention.
the whole machine is controlled by plc. set the parameters through the display screen. control the machine in combination with the control box. audible and visual alarm is activated in case of failure and the failed part will be displayed on the lcd. the whole machine is easy to be handled and set with good interface.
major technical parameters:
dimensions: 1800x1500x1500 (l×w×h) mm
equipment weight: about 500kg
input voltage: 220 v ac 50/60hz
operating pressure: 0.5～0.7mpa
o.d. of rotor: φ20-φ80mm (special types need to be ordered.)
stack thickness of rotor: 20-80mm (special types need to be ordered.)
number of slotsr: 8-36 (even number)
length of rotor shaft: 80-220mm (special types need to be ordered.)
diameter of rotor shaft: φ8-φ22mm